The two battery-powered tools AL-1 45° and 90° are ideally suitable for mass point milling and deburring of rivet holes in titanium, steel, carbon fibre materials and light metals.
With these tools, an optimal problem solution is created for areas of application in the industrial machining of bores that are difficult to access and cannot be machined by automation.

• Fully equipped AL-1 Kit with AL-1 45° and AL-1 90° for lowering ground points.
• The eye-catching orange colour helps to prevent FOD (Foreign Object Damage) accidents, which is why the set is often used in aircraft maintenance.
• The precisely fitting storage compartments in the case make it possible to check at a glance whether all tools are complete again after the work is done.
• Contains tools for easy replacement of the collet
• Padded transport case for a quick change of workstation

AL-1 45°:

• Speed: 400 rpm
• Power supply: LI battery 3.7 Volt, 2600 mAh
• Length: 285 mm
• Max. Diameter: 33 mm
• Weight: 317 g
• Collets: ⌀ 1.6 mm - 2.35 mm - 3 mm - 1/8"
• Head: 45°
• Charging time: 3 h
• Sound pressure level: 45 dB

AL-1 90°:

• Speed: 400 rpm
• Power supply: LI battery 3.7 Volt, 2600 mAh
• Length: 291 mm
• Max. Diameter: 33 mm
• Weight: 316 g
• Collets: ⌀ 1.6 mm - 2.35 mm - 3 mm - 1/8"
• Head: 90°
• Charging time: 3 h
• Sound pressure level: 45 dB(A)

LINO-1:

• Mains voltage: 100...240 VAC, 6 W, 50/60 Hz
• Charging voltage: 3.7 VDC, 700 mA, 2.59 VA
• Standby power consumption: <0.1 mW
• Protection class: ll
• Weight of plug-in charger: 65 g
• Weight of charging station: 175 g

Case:

• Dimensions: L 330 x W 250 x H 70 mm
• Weight: 2.5 kg

• AL-1 45° with 3 mm collet + clamping pin
• AL-1 90° with 3 mm collet + clamping pin
• Collet wrench kit 45° / 90°
• Lino-1 charging station
• Plug-in power supply
• Padded case
• Instruction manual

Tools:

• Ground point countersink Ø 11 shank 2.94 mm, tang 13 mm
• Counterbore Ø 11 shank 3.18 mm, tang 13 mm
• Mass point countersink Ø 14 shank 4.94 mm, tang 16 mm
• Mass point countersink Ø 11 shank 4.70 mm, tang 13 mm
• Mass point countersink Ø 14 shank 4.70 mm, tang 16 mm
• Mass countersink Ø 16 shank 6.26 mm, tang 18 mm
• Countersink Ø 14, 4.70 mm, 16 mm